Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Open the Melitta Caffeo Solo
  • 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackMelitta Caffeo Solo

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Open the Melitta Caffeo Solo
  • Pull out the power cord!
  • Remove the water tank and drainage tray.
  • Remove the side cover and remove the brewing unit.
  • Remove all coffee beans.

Pull out the power cord!

Remove the water tank and drainage tray.

Remove the side cover and remove the brewing unit.

Remove all coffee beans.

1024

Step 2

  • Unscrew and remove six Torx T10 on the rear.
  • Lever the rear cover off. It will most likely be quite stuck and you will need to apply some force. You must use plastic lever tools to prevent damaging the cover.

Unscrew and remove six Torx T10 on the rear.

Lever the rear cover off. It will most likely be quite stuck and you will need to apply some force. You must use plastic lever tools to prevent damaging the cover.

Step 3

  • Press carefully into the slits on the sides using a minus screwdriver or a flat metal spatula, to release the clasps on the upper surface. These may be well tight and you have to use some force.
  • You should have created a separation between the upper surface and side panels. Now lever the upper covering away using a plastic tool. This may be quite stuck and you may apply some force.

Press carefully into the slits on the sides using a minus screwdriver or a flat metal spatula, to release the clasps on the upper surface. These may be well tight and you have to use some force.

You should have created a separation between the upper surface and side panels. Now lever the upper covering away using a plastic tool. This may be quite stuck and you may apply some force.

Step 4

  • Place a plastic tool in the crack between front panel and left side panel and widen it. Then push the side panel to the back. The side panel will be quite stuck and you may apply some force to do this.
  • Remove the hose from the water tank to the pump.
  • Remove the side panel.

Place a plastic tool in the crack between front panel and left side panel and widen it. Then push the side panel to the back. The side panel will be quite stuck and you may apply some force to do this.

Remove the hose from the water tank to the pump.

Remove the side panel.

Step 5

  • Place a plastic tool into the crack between the front panel and the right side panel and widen it. Then push the side panel to the back. This may be quite stuck and you may need to apply some force.
  • Remove the side panel.

Place a plastic tool into the crack between the front panel and the right side panel and widen it. Then push the side panel to the back. This may be quite stuck and you may need to apply some force.

Follow the steps in reverse order to reassemble the device.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.                                             


        These translators are helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

jana°

VauWeh

Author

                                      with 1 other contributor 


                    VauWeh

Member since: 10/19/2015

160,518 Reputation

                                      211 Guides authored                  



                       Badges:
                       41







                                                        +38 more badges