Open The Quickmill 05000A Fully Automatic Espresso Machine Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

• Open
• 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackQuickmill 05000A

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Step 1

              Open               

• Never forget to unplug the power cord!
• Remove the water tank, pulp drawer and bean container.

Never forget to unplug the power cord!

Remove the water tank, pulp drawer and bean container.

1024

Step 2

• Remove two Phillips screws at the top.
• Remove four Phillips screws from the back panel. They are very deep and you need a screwdriver with a very long shaft.
• Remove three Phillips screws from the bottom of the back panel

Remove two Phillips screws at the top.

Remove four Phillips screws from the back panel. They are very deep and you need a screwdriver with a very long shaft.

Remove three Phillips screws from the bottom of the back panel

Step 3

• Unscrew the two Phillips screws on both sides of the back.
• Then pull the back part backwards. Watch out for the power cord.

Unscrew the two Phillips screws on both sides of the back.

Then pull the back part backwards. Watch out for the power cord.

Step 4

• Open the front door.
• The front part is still attached with two Phillips screws. turn them out.

Open the front door.

The front part is still attached with two Phillips screws. turn them out.

Step 5

• The front part now only hangs with cables on the connection buttons of the control panel. In order to get better access to the brew group or the grinder, it is sufficient to push the front part forward about 10 cm. If that’s not enough, you have to free the control panel.

The front part now only hangs with cables on the connection buttons of the control panel. In order to get better access to the brew group or the grinder, it is sufficient to push the front part forward about 10 cm. If that’s not enough, you have to free the control panel.

Work the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating › 

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 

                    VauWeh                     

Member since: 10/19/2015

160,518 Reputation

                                      211 Guides authored                  



                       Badges:
                       41







                                                        +38 more badges