Difficulty

Easy

Steps

4

Time Required

                          5 minutes

Sections

1

  • Top Cover
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackbObi Robotic Vacuum

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

To reassemble bObi, refer to the closing guide. Closing bObi’s Cover Post-Repair

What you need

Step 1

              Top Cover
  • Remove bObi’s front wheel to access one of the screws holding bObi together.
  • Make sure the wheel is turned closer to bObi’s front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.
  • Uninstall the larger screw that sits deeper in the wheel compartment.

Remove bObi’s front wheel to access one of the screws holding bObi together.

Make sure the wheel is turned closer to bObi’s front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.

Uninstall the larger screw that sits deeper in the wheel compartment.

1024

Step 2

  • Remove bObi’s dustbin.
  • Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.

Remove bObi’s dustbin.

Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.

Step 3

  • Lift the brush holder. To detach completely, unplug it from bObi.
  • Remove the two screws on the dustbin contact point holder inside bObi.
  • There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.

Lift the brush holder. To detach completely, unplug it from bObi.

Remove the two screws on the dustbin contact point holder inside bObi.

There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.

Step 4

  • Detach the two circuit plugs connecting bObi’s cover to the main board and the cover will be completely removed.

Detach the two circuit plugs connecting bObi’s cover to the main board and the cover will be completely removed.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Chelsea

Member since: 09/24/2014

2,278 Reputation

                                      31 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges