Opening Case Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          3 - 5 minutes            

Sections

1

• Opening Case
• 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• Back8BitDo SN30 Pro+ Controller

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove Battery               

• Place the controller face down.
• Remove the battery cover.
• Remove rechargeable battery or AA batteries.

Place the controller face down.

Remove the battery cover.

Remove rechargeable battery or AA batteries.

1024

Step 2

              Remove Trigger Buttons               

• Remove L2 and R2 trigger buttons by pushing them away from the grips.

Remove L2 and R2 trigger buttons by pushing them away from the grips.

Step 3

              Remove Screws               

• Use Tweezers to uncover two screws under the label in the battery compartment.
• Use a T6 screwdriver to remove the four 7.3 mm screws securing the rear cover.

Use Tweezers to uncover two screws under the label in the battery compartment.

Use a T6 screwdriver to remove the four 7.3 mm screws securing the rear cover.

Step 4

              Unclip Covers               

• At the end of each grip, pry apart the covers.
• Use fingernail or opening pick to undo the two top clips.
• One clip next to L button.
• One clip next to R button
• Undo the final clip between the joysticks.

At the end of each grip, pry apart the covers.

Use fingernail or opening pick to undo the two top clips.

One clip next to L button.

One clip next to R button

Undo the final clip between the joysticks.

Step 5

              Separate Covers               

• Carefully move the rear cover away and from the front cover. Place it to the left.
• Do not completely separate. The two halves are still attached via a white ribbon cable.

Carefully move the rear cover away and from the front cover. Place it to the left.

Do not completely separate. The two halves are still attached via a white ribbon cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Brian W                     

Member since: 12/21/2011

1,080 Reputation

                                      8 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges