Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

1

  • Opening Philips Senseo Quadrante
  • 6 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackPhilips Senseo Quadrante

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Opening Philips Senseo Quadrante
  • Never forget: Power off and unplug your device before starting repairs!
  • Remove all attachments such as cup rack, pod holder and water tank.

Never forget: Power off and unplug your device before starting repairs!

Remove all attachments such as cup rack, pod holder and water tank.

1024

Step 2

  • Turn the device so that the rear of the machine is facing you.
  • Remove the two Torx T15 screws at the bottom on the machine.

Turn the device so that the rear of the machine is facing you.

Remove the two Torx T15 screws at the bottom on the machine.

Step 3

  • The side panel must first be detached at the bottom edge. Turn the machine so that the bottom is facing towards you.
  • There are two indentations on the base plate with catches inside each one. Press in the catches with a screwdriver and detach the side panel at the bottom edge.
  • Chances are the plate will get stuck. It is recommended that you use a plastic pry tool to avoid scratching.

The side panel must first be detached at the bottom edge. Turn the machine so that the bottom is facing towards you.

There are two indentations on the base plate with catches inside each one. Press in the catches with a screwdriver and detach the side panel at the bottom edge.

Chances are the plate will get stuck. It is recommended that you use a plastic pry tool to avoid scratching.

Step 4

  • At this point, the side panel is still snapped into place on the front, right next to the coffee spout. You can use a screwdriver to carefully pry the latch open.
  • On the inside of the side panel there are two pegs on the top edge that fit in the holes. Lift the side panel up and out.

At this point, the side panel is still snapped into place on the front, right next to the coffee spout. You can use a screwdriver to carefully pry the latch open.

On the inside of the side panel there are two pegs on the top edge that fit in the holes. Lift the side panel up and out.

Step 5

  • The heating element can be seen immediately after the side panel is removed.

The heating element can be seen immediately after the side panel is removed.

Step 6

  • User a screwdriver to release the catch at the top of the electronics cover.
  • Lift out the cover.
  • Both the electronics and the pump will be visible once the cover is removed.

User a screwdriver to release the catch at the top of the electronics cover.

Lift out the cover.

Both the electronics and the pump will be visible once the cover is removed.

Follow the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

        These translators are helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Jacob Mehnert

Abel Levie

Annika Faelker

Author

                                      with 1 other contributor 


                    VauWeh

Member since: 10/19/2015

160,518 Reputation

                                      211 Guides authored                  



                       Badges:
                       41







                                                        +38 more badges