Difficulty

Moderate

Steps

5

Time Required

                          5 minutes

Sections

1

  • Opening the Samsung Galaxy Watch Active
  • 5 steps

Flags

0

  • BackSamsung Galaxy Watch Active

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Turn off the watch
  • Turn off the Galaxy Watch Active by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.
  • When the “Power off” symbol appears tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.

Turn off the Galaxy Watch Active by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.

When the “Power off” symbol appears tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.

1024

Step 2

              Remove the rear screws
  • Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.

Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.

Step 3

              Separate the back cover from the housing
  • Use an opening tool and place it between the plastic back cover and the metal housing near the buttons.
  • Push the tip of the opening tool into the gap to separate the back cover from the housing.
  • Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.

Use an opening tool and place it between the plastic back cover and the metal housing near the buttons.

Push the tip of the opening tool into the gap to separate the back cover from the housing.

Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.

Step 4

              Disconnect the sensor array
  • Carefully lift the back cover approximately 2 cm to access the sensor array connector near the two buttons.
  • Use a spudger to disconnect the sensor array from the motherboard.

Carefully lift the back cover approximately 2 cm to access the sensor array connector near the two buttons.

Use a spudger to disconnect the sensor array from the motherboard.

Step 5

              Remove the back cover
  • Remove the back cover.

Remove the back cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                    Tobias Isakeit

Member since: 03/31/2014

105,397 Reputation

                                      184 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored