Difficulty
Moderate
Steps
8
Time Required
15 - 20 minutes
Sections
3
- Battery
- 2 steps
- Chassis
- 4 steps
- Volume Button
- 2 steps
Flags
0
BackOppo X9000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Removing the Back Cover
- Turn the phone over so that you are facing the back side of the phone.
- With your fingers, pry the back cover up starting from the top of the phone near the headphone jack and camera.
- Completely remove the back cover by moving down the sides and bottom with your fingers.
Turn the phone over so that you are facing the back side of the phone.
With your fingers, pry the back cover up starting from the top of the phone near the headphone jack and camera.
Completely remove the back cover by moving down the sides and bottom with your fingers.
1024
Step 2
Removing the Battery
- With your finger, remove the battery from the phone by gently lifting the top-right corner nearest to the camera.
With your finger, remove the battery from the phone by gently lifting the top-right corner nearest to the camera.
Step 3
Remove the Back Panel Screws
- Remove the twelve exposed 3.6 mm Phillips screws on the rear of the phone using the 3.6 mm Phillips screwdriver.
- Store all the screws in a safe place where you will not lose them.
Remove the twelve exposed 3.6 mm Phillips screws on the rear of the phone using the 3.6 mm Phillips screwdriver.
Store all the screws in a safe place where you will not lose them.
Step 4
Remove the Rubber Stoppers
- Remove the three circular rubber screw covers on the back of the phone by slipping the spudger into the border between the rubber cover and the chassis. In one motion, pry the stopper out of the hole. This can take some force.
Remove the three circular rubber screw covers on the back of the phone by slipping the spudger into the border between the rubber cover and the chassis. In one motion, pry the stopper out of the hole. This can take some force.
Step 5
Remove the Newly Exposed Screws
- With the 3.6 mm Phillips screwdriver, remove the three newly exposed 3.6mm Phillips screws.
With the 3.6 mm Phillips screwdriver, remove the three newly exposed 3.6mm Phillips screws.
Step 6
Lift off the Back Panel
- Insert the plastic opening tool underneath the chassis near the power button and pry the chassis from the phone. This should take a little force.
Insert the plastic opening tool underneath the chassis near the power button and pry the chassis from the phone. This should take a little force.
Step 7
Remove the Volme Button Bracket
- Use the sharp end of the spudger to pry the volume button bracket from the side of the rear case.
Use the sharp end of the spudger to pry the volume button bracket from the side of the rear case.
Step 8
Let the Button Fall Out
- Rotate the phone onto its side so that the volume button falls out with ease.
- Make sure not to lose the volume button.
Rotate the phone onto its side so that the volume button falls out with ease.
Make sure not to lose the volume button.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Joe Hanacek
Member since: 10/14/2014
520 Reputation
2 Guides authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 4-45, Amido Fall 2014
Member of Cal Poly, Team 4-45, Amido Fall 2014
CPSU-AMIDO-F14S4G45
5 Members
11 Guides authored
