Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Disassembling Optoma HD20 Cover
- 4 steps
- Air Filter
- 2 steps
Flags
1
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
BackOptoma HD20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembling Optoma HD20 Cover
- Twist the focal cap clockwise until it is fully extended.
- Remove the focal cap by pulling it straight out.
Twist the focal cap clockwise until it is fully extended.
Remove the focal cap by pulling it straight out.
1024
Step 2
- Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.
Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.
Step 3
- Use a plastic opening tool to gently pry the top cover off of the device.
- It is easier to pry off the cover from the back side just above the HDMI ports.
Use a plastic opening tool to gently pry the top cover off of the device.
It is easier to pry off the cover from the back side just above the HDMI ports.
Step 4
- When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.
- Remove the ribbon by disconnecting it from the main circuit board.
- Lift up the clip holding it down and pull the ribbon out.
When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.
Remove the ribbon by disconnecting it from the main circuit board.
Lift up the clip holding it down and pull the ribbon out.
Step 5
Air Filter
- Carefully peel off each air filter from the device
- Pull up on the air filter to remove it.
Carefully peel off each air filter from the device
Pull up on the air filter to remove it.
Step 6
- Remove the air filter from the device.
- Try not to deposit dirt from the air filter into the inside of the device.
Remove the air filter from the device.
Try not to deposit dirt from the air filter into the inside of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Trever
Member since: 01/22/2015
1,220 Reputation
6 Guides authored
Badges:
20
+17 more badges
Team
Cal Poly, Team 21-23, Maness Winter 2015
Member of Cal Poly, Team 21-23, Maness Winter 2015
CPSU-MANESS-W15S21G23
4 Members
6 Guides authored
Michael - Feb 4, 2021
Reply
There were no filters where the photos indicate.