Difficulty
Moderate
Steps
10
Time Required
10 minutes
Sections
1
- Back Case
- 10 steps
Flags
0
BackOrdro HDV-D395
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Case
- Pull the slider labeled open, on the bottom right, to unlock the battery.
Pull the slider labeled open, on the bottom right, to unlock the battery.
1024
Step 2
- Pull battery out of slot.
Pull battery out of slot.
Step 3
- Unfold the screen from the side of the camera.
Unfold the screen from the side of the camera.
Step 4
- Twist the screen so that the screen is facing downward.
Twist the screen so that the screen is facing downward.
Step 5
- Unscrew the four screws on the side (length 2.9 mm) with a JIS #000 screwdriver.
- Unscrew the three screws on the bottom (length 7.7 mm) with a JIS #000 screwdriver.
Unscrew the four screws on the side (length 2.9 mm) with a JIS #000 screwdriver.
Unscrew the three screws on the bottom (length 7.7 mm) with a JIS #000 screwdriver.
Step 6
- Pull apart the camera into two pieces by pulling the side with the screen away from the main body of the camera.
Pull apart the camera into two pieces by pulling the side with the screen away from the main body of the camera.
Step 7
- Unscrew the two screws (size 4.75 mm) with a PH #00 screwdriver.
- Unscrew the screw (size 7.65 mm) with a PH #00 screwdriver.
Unscrew the two screws (size 4.75 mm) with a PH #00 screwdriver.
Unscrew the screw (size 7.65 mm) with a PH #00 screwdriver.
Step 8
- Take the back case off by pulling it away from the main body.
- Be careful not to tear the white strap that connects the back case to the main body.
Take the back case off by pulling it away from the main body.
Be careful not to tear the white strap that connects the back case to the main body.
Step 9
- Unscrew all four screws (length 4.13 mm) on the inside of the case with a PH #00 screwdriver.
Unscrew all four screws (length 4.13 mm) on the inside of the case with a PH #00 screwdriver.
Step 10
- Pull the board away from the back case.
Pull the board away from the back case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Mostafa Abdulaleem
Member since: 11/05/2018
181 Reputation
1 Guide authored
Badges:
2
Team
IUPUI, Team S1-G3, Baechle Fall 2018
Member of IUPUI, Team S1-G3, Baechle Fall 2018
IUPUI-BAECHLE-F18S1G3
3 Members
3 Guides authored
