Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
2
- Oregon Scientific Meep! 4.0 Disassembly
- 2 steps
- Motherboard
- 3 steps
Flags
0
BackOregon Scientific Meep! 4.0
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Oregon Scientific Meep! 4.0 Disassembly
- Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.
Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.
1024
Step 2
- Use a plastic opening tool to detach the clips on the inside of the device.
Use a plastic opening tool to detach the clips on the inside of the device.
Step 3
Motherboard
- Use a soldering station to disconnect any wires attached to the motherboard.
Use a soldering station to disconnect any wires attached to the motherboard.
Step 4
- Use a screwdriver to unscrew the three 4.0 mm Philips #00 screws holding the motherboard in place.
Use a screwdriver to unscrew the three 4.0 mm Philips #00 screws holding the motherboard in place.
Step 5
- Use a plastic opening tool to release the ribbon cables surrounding the motherboard.
Use a plastic opening tool to release the ribbon cables surrounding the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Lauren Milici
Member since: 09/21/2015
216 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
University of Tampa, Team 1-3, Whiteside Fall 2015
Member of University of Tampa, Team 1-3, Whiteside Fall 2015
UT-WHITESIDE-F15S1G3
3 Members
12 Guides authored
