Difficulty

Difficult

Steps

6

Time Required

                          20 minutes

Sections

2

  • Rear Casing
  • 3 steps
  • Battery
  • 3 steps

Flags

0

  • BackOregon Scientific Meep! X2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Casing
  • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

1024

Step 2

  • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

Step 3

  • Use the plastic opening tools to undo the clips around the edges of the device.

Use the plastic opening tools to undo the clips around the edges of the device.

Step 4

              Remove the ribbon cable.
  • Gently unhook the black security clips to loosen the ribbon cable. Use one of the plastic opening tools.
  • Pull lightly on the ribbon cable to remove it.

Gently unhook the black security clips to loosen the ribbon cable. Use one of the plastic opening tools.

Pull lightly on the ribbon cable to remove it.

Step 5

              Sever the adhesive glue on the battery.
  • Use your spudger to separate the battery from the adhesive glue strips and plastic film.

Use your spudger to separate the battery from the adhesive glue strips and plastic film.

Step 6

  • Use a soldering station to unsolder the battery wires from the motherboard.
  • In the case of screen or screen sensor replacement, disregard desoldering steps.

Use a soldering station to unsolder the battery wires from the motherboard.

In the case of screen or screen sensor replacement, disregard desoldering steps.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    J'mel Henneman

Member since: 01/20/2015

864 Reputation

                                      8 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 9-1, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-1, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G1                     


                                            3 Members                     


                                            16 Guides authored