Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

2

  • Rear Casing
  • 3 steps
  • Cameras
  • 3 steps

Flags

0

  • BackOregon Scientific Meep! X2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Casing
  • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

1024

Step 2

  • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

Step 3

  • Use the plastic opening tools to undo the clips around the edges of the device.

Use the plastic opening tools to undo the clips around the edges of the device.

Step 4

              Cameras
  • Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard.

Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard.

Step 5

  • Pry the second camera out of its slot with one of the plastic opening tools.
  • Be sure to undo the black adhesive foam from the metal casing in order to remove the camera properly.

Pry the second camera out of its slot with one of the plastic opening tools.

Be sure to undo the black adhesive foam from the metal casing in order to remove the camera properly.

Step 6

  • Release the black security clip on the ribbon cable with your plastic opening tool.
  • Gently disconnect the gold ribbon cable from the motherboard. The two cameras will remain attached to the ribbon cable.

Release the black security clip on the ribbon cable with your plastic opening tool.

Gently disconnect the gold ribbon cable from the motherboard. The two cameras will remain attached to the ribbon cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    J'mel Henneman

Member since: 01/20/2015

864 Reputation

                                      8 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 9-1, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-1, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G1                     


                                            3 Members                     


                                            16 Guides authored