Difficulty
Difficult
Steps
5
Time Required
15 minutes
Sections
2
- Rear Casing
- 3 steps
- Power Button
- 2 steps
Flags
0
BackOregon Scientific Meep! X2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Casing
- Remove the orange covers from the left and right sides of the device by sliding up against the tabs.
Remove the orange covers from the left and right sides of the device by sliding up against the tabs.
1024
Step 2
- You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.
You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.
Step 3
- Use the plastic opening tools to undo the clips around the edges of the device.
Use the plastic opening tools to undo the clips around the edges of the device.
Step 4
Power Button
- Use a tweezer to gently pull the power button sensor out of the case’s slot.
Use a tweezer to gently pull the power button sensor out of the case’s slot.
Step 5
- Use the soldering station to unsolder and remove the power button from the motherboard.
- In the case of screen or screen sensor replacement, disregard desoldering steps.
Use the soldering station to unsolder and remove the power button from the motherboard.
In the case of screen or screen sensor replacement, disregard desoldering steps.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
J'mel Henneman
Member since: 01/20/2015
864 Reputation
8 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 9-1, Blackwell Winter 2015
Member of USF Tampa, Team 9-1, Blackwell Winter 2015
USFT-BLACKWELL-W15S9G1
3 Members
16 Guides authored
