Oster 6329 Bread Grabber Spring Replacement Repair Guide

Difficulty

Very difficult

Steps

Time Required

                          25 - 30 minutes

Sections

Outer Shell Removal
5 steps
Bread Grabber Spring
4 steps

Flags

BackOster 6329
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Outer Shell Removal

Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

1024

Step 2

Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

Step 3

Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.
Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.

Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

Step 4

Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

Step 5

Lift the top outer metal shell.
Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

Lift the top outer metal shell.

Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

Step 6

              Bread Grabber Spring

Press down on the toaster handle to access to the grabber spring located behind the large metal plate.

Press down on the toaster handle to access to the grabber spring located behind the large metal plate.

Step 7

Locate the grabber spring.

Locate the grabber spring.

Step 8

Use the large needle nose pliers to unwind the grabber spring from one side of the carriage to remove.
Repeat this step for the opposite side.

Use the large needle nose pliers to unwind the grabber spring from one side of the carriage to remove.

Repeat this step for the opposite side.

Step 9

Remove the old spring from the toaster unit to insert new.

Remove the old spring from the toaster unit to insert new.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 6 other contributors

                    Isaac Williams

Member since: 01/24/2014

225 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 13-15, Regan Winter 2014                        

                                                  Member of Cal Poly, Team 13-15, Regan Winter 2014 



                    CPSU-REGAN-W14S13G15                     


                                            5 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team