Oster 6329 Lever Catch Spring Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Outer Shell Removal
5 steps
Lever Catch Spring
3 steps

Flags

BackOster 6329
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Outer Shell Removal

Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

1024

Step 2

Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

Step 3

Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.
Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.

Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

Step 4

Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

Step 5

Lift the top outer metal shell.
Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

Lift the top outer metal shell.

Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

Step 6

              Lever Catch Spring

Insert the tweezers between the spring and the bottom of the lever to release the spring.

Insert the tweezers between the spring and the bottom of the lever to release the spring.

Step 7

Remove spring from the bottom of the lever.
The spring should only be connected to the top of the toaster after this is complete.

Remove spring from the bottom of the lever.

The spring should only be connected to the top of the toaster after this is complete.

Step 8

Insert the tweezers between the two metal flaps located at the top of the toaster.
Hold the spring and turn it sideways to lay it flat along the top of the toaster.
Pry the spring from the top of the toaster.

Insert the tweezers between the two metal flaps located at the top of the toaster.

Hold the spring and turn it sideways to lay it flat along the top of the toaster.

Pry the spring from the top of the toaster.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors

                    Blaine Oelkers

Member since: 01/24/2014

113 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team 13-15, Regan Winter 2014                        

                                                  Member of Cal Poly, Team 13-15, Regan Winter 2014 



                    CPSU-REGAN-W14S13G15                     


                                            5 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team