Difficulty
Difficult
Steps
5
Time Required
30 minutes
Sections
1
- Circuitboard
- 5 steps
Flags
0
BackOster BLSTSS-PZO
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuitboard
- Use the prying tools to open the four plastic screw holes on the bottom of the blender.
Use the prying tools to open the four plastic screw holes on the bottom of the blender.
1024
Step 2
- Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.
Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.
Step 3
- Gently remove the circuit board.
Gently remove the circuit board.
Step 4
- Use the spudger to detach the black wire from the circuit board.
- Repeat for yellow wire.
Use the spudger to detach the black wire from the circuit board.
Repeat for yellow wire.
Step 5
- Use the Phillips #1 to remove the four 8mm screws.
- Use the medal spudger to detach the circuit board from the buttons.
- Gently pull and release circuit board from buttons.
Use the Phillips #1 to remove the four 8mm screws.
Use the medal spudger to detach the circuit board from the buttons.
Gently pull and release circuit board from buttons.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Tristian Cruz
Member since: 09/20/2017
263 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
University of North Texas, Team S7-G8, Thomas Fall 2017
Member of University of North Texas, Team S7-G8, Thomas Fall 2017
UNT-THOMAS-F17S7G8
3 Members
4 Guides authored
