Difficulty

Moderate

Steps

8

Time Required

                          20 minutes

Sections

2

  • Circuitboard
  • 5 steps
  • Power Cord
  • 3 steps

Flags

0

  • BackOster BLSTSS-PZO

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Circuitboard
  • Use the prying tools to open the four plastic screw holes on the bottom of the blender.

Use the prying tools to open the four plastic screw holes on the bottom of the blender.

1024

Step 2

  • Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.

Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.

Step 3

  • Gently remove the circuit board.

Gently remove the circuit board.

Step 4

  • Use the spudger to detach the black wire from the circuit board.
  • Repeat for yellow wire.

Use the spudger to detach the black wire from the circuit board.

Repeat for yellow wire.

Step 5

  • Use the Phillips #1 to remove the four 8mm screws.
  • Use the medal spudger to detach the circuit board from the buttons.
  • Gently pull and release circuit board from buttons.

Use the Phillips #1 to remove the four 8mm screws.

Use the medal spudger to detach the circuit board from the buttons.

Gently pull and release circuit board from buttons.

Step 6

              Power Cord
  • Locate petal prong on the end of the power cord.
  • Bend metal prong until it’s straight with your finger.

Locate petal prong on the end of the power cord.

Bend metal prong until it’s straight with your finger.

Step 7

  • Spring will pop out when you pull out metal prong
  • Pull prong out of the hole.

Spring will pop out when you pull out metal prong

Pull prong out of the hole.

Step 8

  • Pinch plastic prongs on base of blender to remove plastic securing device.
  • Remove plastic securing device.
  • Pull power cord out of blender base.

Pinch plastic prongs on base of blender to remove plastic securing device.

Remove plastic securing device.

Pull power cord out of blender base.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Loren Hyer

Member since: 09/20/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of North Texas, Team S7-G8, Thomas Fall 2017                        

                                                  Member of University of North Texas, Team S7-G8, Thomas Fall 2017 



                    UNT-THOMAS-F17S7G8                     


                                            3 Members                     


                                            4 Guides authored