Difficulty

Moderate

Steps

11

Time Required

                          20 minutes

Sections

2

  • Top Panel Removal
  • 4 steps
  • Inner Chamber
  • 7 steps

Flags

0

  • BackOster Expressbake CKSTBRTW20

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Panel Removal
  • Remove the bread pan.

Remove the bread pan.

1024

Step 2

  • Remove the eight 22mm Phillips #1 screws from the grey lining.
  • Remove the grey liner.

Remove the eight 22mm Phillips #1 screws from the grey lining.

Remove the grey liner.

Step 3

  • Remove the two 11mm Phillips #1 screws from the back of the device.

Remove the two 11mm Phillips #1 screws from the back of the device.

Step 4

  • Pop off the top case using a spudger.
  • Keep the spudger away from the control panel.
  • Be aware of wires connecting the microcontroller to the panel when removing the top lining.

Pop off the top case using a spudger.

Keep the spudger away from the control panel.

Be aware of wires connecting the microcontroller to the panel when removing the top lining.

Step 5

              Inner Chamber
  • Disconnect microcontroller and top lining.
  • Ground yourself prior to disconnecting in order to avoid harming the inner electronics.

Disconnect microcontroller and top lining.

Ground yourself prior to disconnecting in order to avoid harming the inner electronics.

Step 6

  • Remove the four 11mm Phillips #1 screws holding from the guard and inner lining.
  • Remove small rectangular guard from bottom of liner

Remove the four 11mm Phillips #1 screws holding from the guard and inner lining.

Remove small rectangular guard from bottom of liner

Step 7

  • Remove the inner liner.
  • The inner liner will be connected to the outer chamber with wires.

Remove the inner liner.

The inner liner will be connected to the outer chamber with wires.

Step 8

  • Disconnect the red wires from the inner liner.

Disconnect the red wires from the inner liner.

Step 9

  • Remove the single 11mm Phillips #1 screw thats holding and inner lining in place.

Remove the single 11mm Phillips #1 screw thats holding and inner lining in place.

Step 10

  • Use a spudger to push out the connector found on the inner lining.

Use a spudger to push out the connector found on the inner lining.

Step 11

  • Remove lining.

Remove lining.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Megan Saunders

Member since: 01/25/2018

701 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team S7-G5, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G5, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G5                     


                                            4 Members                     


                                            5 Guides authored