Overhead Door Remote Battery Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          2 minutes

Sections

Battery
4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackOverhead Door Remote Model O3T
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Opening the door

Insert your screwdriver into the plastic tab, then pull up.
Now go to the bottom near where it says Overhead Door and pull up, it should pop up. Once that is open push forward and the top should release
Note: It may be easier to use your finger

Insert your screwdriver into the plastic tab, then pull up.

Now go to the bottom near where it says Overhead Door and pull up, it should pop up. Once that is open push forward and the top should release

Note: It may be easier to use your finger

1024

Step 2

              Getting the board out.

Take your screwdriver and push it into the bottom left corner of the board as shown on the picture. Once you have it in their good, pull up lightly, the board should come up and out.

Take your screwdriver and push it into the bottom left corner of the board as shown on the picture. Once you have it in their good, pull up lightly, the board should come up and out.

Step 3

              Arming the remote.

Flip the board over, you should see the battery. Take your screwdriver and push the battery out gently.
Take care not to damage anything! Especially the battery!
Now that the old battery is out. Put the new one in, Words up.

Flip the board over, you should see the battery. Take your screwdriver and push the battery out gently.

Take care not to damage anything! Especially the battery!

Now that the old battery is out. Put the new one in, Words up.

Step 4

              Put the thing together.

Now flip the board over and put it in it’s case. You should feel a light click. Remember not to be too hard.
When you got the board on, simply take the top part, be mindful of the rubber, and snap it on, the top first then the bottom. You can use the pictures above if you don’t know where it is
Note: It will take you a bit of time to get the shell back together, be patient and you will get it.

Now flip the board over and put it in it’s case. You should feel a light click. Remember not to be too hard.

When you got the board on, simply take the top part, be mindful of the rubber, and snap it on, the top first then the bottom. You can use the pictures above if you don’t know where it is

Note: It will take you a bit of time to get the shell back together, be patient and you will get it.

There you go! A fully functioning remote. Give yourself a pat on the back and go get a drink of water.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Repair Skeleton

Member since: 08/23/2021

651 Reputation

                                      1 Guide authored                  



                       Badges:
                       18







                                                        +15 more badges

Member-Contributed Guide#

Introduction#

What you need#

#

#

#

#

#

#

Member-Contributed Guide

Introduction

What you need