Difficulty

Moderate

Steps

9

Time Required

                          5 - 8 minutes

Sections

1

  • Bulb Panel
  • 9 steps

Flags

3

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackPacific Image Electronics CS3600

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bulb Panel
  • Start by removing the 5 screws that are 5mm x 9mm located on the bottom of the device with a J1 screwdriver.

Start by removing the 5 screws that are 5mm x 9mm located on the bottom of the device with a J1 screwdriver.

1024

Step 2

  • Now that the screws have been removed, carefully but firmly open up the device at the seam until it is presented as shown.

Now that the screws have been removed, carefully but firmly open up the device at the seam until it is presented as shown.

Step 3

  • Use a J0 screwdriver to remove the following four screws that are 5mm x 9mm.

Use a J0 screwdriver to remove the following four screws that are 5mm x 9mm.

Step 4

  • Use the same J0 screwdriver to remove the following 3 screws that are 7mm x 6mm.

Use the same J0 screwdriver to remove the following 3 screws that are 7mm x 6mm.

Step 5

  • Now grab the plastic cover you just removed screws from and gently remove it from the device.

Now grab the plastic cover you just removed screws from and gently remove it from the device.

Step 6

  • You may now pick up the plastic covering you removed screws from in Step 3 with ease revealing the bulb.

You may now pick up the plastic covering you removed screws from in Step 3 with ease revealing the bulb.

Step 7

  • Lodge the plastic opening tool underneath the bulb casing. Using some upward force, pop the bulb off the casing.

Lodge the plastic opening tool underneath the bulb casing. Using some upward force, pop the bulb off the casing.

Step 8

  • You have now removed the bulb from the casing. Gently pull the wires forward and prepare a soldering station.

You have now removed the bulb from the casing. Gently pull the wires forward and prepare a soldering station.

Step 9

  • Carefully desolder the 2 wires from their solder contact points to detach the bulb panel from the motherboard.

Carefully desolder the 2 wires from their solder contact points to detach the bulb panel from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Kristen Prince

Member since: 03/21/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Texas Tech, Team S46-G2, Bennett Spring 2017                        

                                                  Member of Texas Tech, Team S46-G2, Bennett Spring 2017 



                    TTU-BENNETT-S17S46G2                     


                                            3 Members                     


                                            5 Guides authored