Difficulty

Moderate

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Battery
  • 2 steps
  • Back Panel
  • 4 steps

Flags

0

  • BackPalm Treo 680

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the battery cover by pressing on the small rectangular button located on the back of the phone.

Remove the battery cover by pressing on the small rectangular button located on the back of the phone.

1024

Step 2

  • Remove the battery by pulling it out towards you.

Remove the battery by pulling it out towards you.

Step 3

              Back Panel
  • Remove the stylus in order to access the screw.
  • Remove the 27mm top-left screw using a T6 Torx screwdriver.

Remove the stylus in order to access the screw.

Remove the 27mm top-left screw using a T6 Torx screwdriver.

Step 4

  • Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.
  • Remove the 27mm screw using the T6 Torx screwdriver.
  • If there is a red Palm sticker covering this screw, puncture it to access the screw.

Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.

Remove the 27mm screw using the T6 Torx screwdriver.

If there is a red Palm sticker covering this screw, puncture it to access the screw.

Step 5

  • Remove the remaining two 27mm screws from the bottom using the T6 screwdriver.

Remove the remaining two 27mm screws from the bottom using the T6 screwdriver.

Step 6

  • Turn the phone so the screen is facing the right side.
  • Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.
  • Separate the covers from the left side of the device as indicated in the picture.
  • The right side contains orange ribbons that are easily damaged.

Turn the phone so the screen is facing the right side.

Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.

Separate the covers from the left side of the device as indicated in the picture.

The right side contains orange ribbons that are easily damaged.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 14 other contributors 


                    Maiya123

Member since: 10/22/2009

51 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 6-4, Maness Fall 2009                        

                                                  Member of Cal Poly, Team 6-4, Maness Fall 2009 



                    CPSU-MANESS-F09S6G4                     


                                            4 Members                     


                                            12 Guides authored