Difficulty

Moderate

Steps

7

Time Required

                          5 minutes

Sections

2

  • Battery
  • 2 steps
  • Back Cover
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackPalm Treo 755p

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Press the button on the back cover to release the battery cover.
  • Slide off the battery cover.

Press the button on the back cover to release the battery cover.

Slide off the battery cover.

1024

Step 2

  • Remove the battery by lifting up on one side.

Remove the battery by lifting up on one side.

Step 3

              Back Cover
  • Remove the stylus by pulling up on the large top to reveal the top left case screw.
  • Pull away the black flap to reveal the top right case screw.

Remove the stylus by pulling up on the large top to reveal the top left case screw.

Pull away the black flap to reveal the top right case screw.

Step 4

  • Use a T5 screwdriver to remove the five 7 mm black/red back case screws.
  • Use a T5 screwdriver to remove the middle 3.1 mm screw.

Use a T5 screwdriver to remove the five 7 mm black/red back case screws.

Use a T5 screwdriver to remove the middle 3.1 mm screw.

Step 5

  • Use the plastic opening tool to pry open the device. Start on the volume control side (left side of the screen) and work your way up along the edge and across the top.
  • The side volume control buttons may fall out after opening the device.

Use the plastic opening tool to pry open the device. Start on the volume control side (left side of the screen) and work your way up along the edge and across the top.

The side volume control buttons may fall out after opening the device.

Step 6

  • Slowly unfold the back casing away from the front casing revealing the red and black wound wire speaker cable, marked by the red box.
  • Potential for device damage: Be gentle while separating the halves to prevent breaking the red and black wound wire speaker cable that bridges both halves.

Slowly unfold the back casing away from the front casing revealing the red and black wound wire speaker cable, marked by the red box.

Potential for device damage: Be gentle while separating the halves to prevent breaking the red and black wound wire speaker cable that bridges both halves.

Step 7

  • Using tweezers, squeeze the plastic head of the black and red wound wire cable. This will detach the cable from the circuit board and fully separate the two halves.

Using tweezers, squeeze the plastic head of the black and red wound wire cable. This will detach the cable from the circuit board and fully separate the two halves.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 10 other contributors 


                    Mike Shaw

Member since: 01/03/2011

601 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 14-6, Forte Winter 2011                        

                                                  Member of Cal Poly, Team 14-6, Forte Winter 2011 



                    CPSU-FORTE-W11S14G6                     


                                            6 Members                     


                                            12 Guides authored