Difficulty
Moderate
Steps
8
Time Required
15 minutes
Sections
1
- Battery
- 8 steps
Flags
4
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackPalm Tungsten E2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Remove Screws from Back
- Open the 4 screws on the back
Open the 4 screws on the back
1024
Step 2
Open Cover
- With a spudger open the case on the side
With a spudger open the case on the side
Step 3
Detach Battery
- Pull the Connector Up
Pull the Connector Up
Step 4
Remove Battery from Back Cover
- Remove the Battery with a plastic spudger
Remove the Battery with a plastic spudger
Step 5
Connect new battery
- Insert the Connector straight downward
Insert the Connector straight downward
Step 6
Attach battery
- Put the battery in the same place, if necessary add glue to it
Put the battery in the same place, if necessary add glue to it
Step 7
Close case
- Close the case and tiden it with the screws
Close the case and tiden it with the screws
Step 8
Finish
- Completely load the battery and push the reset button.
- Adjust date and time
Completely load the battery and push the reset button.
Adjust date and time
Arbeite die Schritte in umgekehrter Reihenfolge ab, um dein Gerät wieder zusammenzubauen.
Cancel: I did not complete this guide.
Author
with 2 other contributors
MacWiniac
Member since: 01/18/2012
153 Reputation
1 Guide authored
Badges:
3