Difficulty
Difficult
Steps
5
Time Required
10 - 20 minutes
Sections
2
- Case
- 4 steps
- Speaker
- 1 step
Flags
0
BackPalm Zire 31
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Case
- Unscrew the two 7.35mm Torx T6 screws.
Unscrew the two 7.35mm Torx T6 screws.
1024
Step 2
- Using the flat end of the spudger, carefully pry the black cover on the top from the blue front cover.
Using the flat end of the spudger, carefully pry the black cover on the top from the blue front cover.
Step 3
- Carefully remove the speaker from the back white cover by just pulling it gently. It is glued on.
Carefully remove the speaker from the back white cover by just pulling it gently. It is glued on.
Step 4
- Unscrew the #00 5.75mm Phillips screws from the bottom of the motherboard. The front blue panel should fall right off.
Unscrew the #00 5.75mm Phillips screws from the bottom of the motherboard. The front blue panel should fall right off.
Step 5
Speaker
- The soldering iron heats up leads, wires, and everything else it touches that is metal. Leaving it on too long may damage the board or burn you.
- Desolder the speaker wires and solder the new speaker in its place.
- The black and red wires are connected to the two solder bulbs in the yellow box.
The soldering iron heats up leads, wires, and everything else it touches that is metal. Leaving it on too long may damage the board or burn you.
Desolder the speaker wires and solder the new speaker in its place.
The black and red wires are connected to the two solder bulbs in the yellow box.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Gabe
Member since: 01/23/2011
501 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 5-21, Amido Winter 2011
Member of Cal Poly, Team 5-21, Amido Winter 2011
CPSU-AMIDO-W11S5G21
4 Members
6 Guides authored