Panasonic Dmc Fz70 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Back Panel
7 steps
LCD Screen
3 steps

Flags

BackPanasonic DMC-FZ70
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

All screws should be removed using a Phillips #0 screwdriver.
Using your screwdriver, unscrew the two 5.0 mm Philips screws to the right of the LCD screen.

All screws should be removed using a Phillips #0 screwdriver.

Using your screwdriver, unscrew the two 5.0 mm Philips screws to the right of the LCD screen.

1024

Step 2

Flip the camera over to the left side of the screen and unscrew the 5mm Phillips screw found there.

Flip the camera over to the left side of the screen and unscrew the 5mm Phillips screw found there.

Step 3

Turn the camera upside down and unscrew the three 5mm screws found on the bottom.

Turn the camera upside down and unscrew the three 5mm screws found on the bottom.

Step 4

On the top of the camera locate the two rails with a thin sheet of metal on the floor between them.
With a metal spudger, lift this sheet and push it out of the rail device to detach it from the camera.

On the top of the camera locate the two rails with a thin sheet of metal on the floor between them.

With a metal spudger, lift this sheet and push it out of the rail device to detach it from the camera.

Step 5

Proceed to remove the four 5mm Phillips screws that you just uncovered.

Proceed to remove the four 5mm Phillips screws that you just uncovered.

Step 6

Slowly pull on both side of the camera, until both halves begin to separate from each other.
Do not pull too hard, as both halves are held together with ZIF connector cables.

Slowly pull on both side of the camera, until both halves begin to separate from each other.

Do not pull too hard, as both halves are held together with ZIF connector cables.

Step 7

Using a plastic opening tool, carefully flip up the small black levers that attach the ribbon cables to the ZIF connectors on the motherboard.
Carefully pull the ribbon cables out of the slot once they have been released.
Only the two indicated connectors need to be removed to separate the two halves of the camera.

Using a plastic opening tool, carefully flip up the small black levers that attach the ribbon cables to the ZIF connectors on the motherboard.

Carefully pull the ribbon cables out of the slot once they have been released.

Only the two indicated connectors need to be removed to separate the two halves of the camera.

Step 8

              LCD Screen

Unscrew the five 5mm screws on the panel that you just removed.

Unscrew the five 5mm screws on the panel that you just removed.

Step 9

Remove the entire silver panel to reveal the back of the LCD screen

Remove the entire silver panel to reveal the back of the LCD screen

Step 10

Remove the LCD screen.

Remove the LCD screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 6 other contributors

                    Alberto Rodriguez

Member since: 01/24/2017

522 Reputation

                                      4 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team 21-3, Maness Winter 2017                        

                                                  Member of Cal Poly, Team 21-3, Maness Winter 2017 



                    CPSU-MANESS-W17S21G3                     


                                            6 Members                     


                                            12 Guides authored

tim krikston - Aug 15, 2017

Where can I find the screen to replace the one that is cracked?

schmitzmichaell - Nov 14, 2017

Try NewEgg.com:

https://www.newegg.com/Product/Product.a…

Ppavan Shetty - May 23, 2018

i am not able to find the new display where-in they could ship it to INDIA

if u find any please mail me - ppavanshetty@gmail.com

Harold De La Matta - May 24, 2018

After replacement the camera won’t work, turn on but it doesn’t work.

After the LCD replacement my camera turn on but it doesn’t work. Any ideas?

Introduction#

What you need#

Team#

Introduction

What you need

Team