Difficulty

Moderate

Steps

11

Time Required

Suggest a time??

Sections

3

  • Battery
  • 3 steps
  • Rear Casing
  • 6 steps
  • Flash Top Assembly
  • 2 steps

Flags

0

  • BackPanasonic Lumix DMC-FX01

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate the memory card and battery card latch on the bottom of the camera.
  • Slide the latch to the open position.

Locate the memory card and battery card latch on the bottom of the camera.

Slide the latch to the open position.

1024

Step 2

  • Open the battery latch, and slide the battery release lever to the right.

Open the battery latch, and slide the battery release lever to the right.

Step 3

  • Remove the battery from the camera.

Remove the battery from the camera.

Step 4

              Rear Casing
  • Remove the three 4.6 mm screws on the bottom of the camera using a Phillips #00 screwdriver.

Remove the three 4.6 mm screws on the bottom of the camera using a Phillips #00 screwdriver.

Step 5

  • Remove the single 3.2 mm screw on the left side of the camera using a Phillips #00 screwdriver.

Remove the single 3.2 mm screw on the left side of the camera using a Phillips #00 screwdriver.

Step 6

  • Remove the left side casing.

Remove the left side casing.

Step 7

  • Remove the two 3.2 mm screws on the right side of the camera using a Phillips #00 screwdriver.

Remove the two 3.2 mm screws on the right side of the camera using a Phillips #00 screwdriver.

Step 8

  • Remove the bottom right panel.

Remove the bottom right panel.

Step 9

  • Gently remove the back casing.
  • Start at the bottom and carefully pry towards the top to get this piece free.

Gently remove the back casing.

Start at the bottom and carefully pry towards the top to get this piece free.

Step 10

              Flash Top Assembly
  • Carefully pry the Flash Top Assembly away from the top.

Carefully pry the Flash Top Assembly away from the top.

Step 11

  • Replace the Flash Top Assembly with a new one.

Replace the Flash Top Assembly with a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Caleb Fink

Member since: 10/11/2010

186 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 9-22, Regan Fall 2010                        

                                                  Member of Cal Poly, Team 9-22, Regan Fall 2010 



                    CPSU-REGAN-F10S9G22                     


                                            4 Members                     


                                            8 Guides authored