Difficulty

Moderate

Steps

5

Time Required

                          15 - 20 minutes

Sections

1

  • Panasonic Lumix DMC-FX37 Disassembly
  • 5 steps

Flags

0

  • BackPanasonic Lumix DMC-FX37

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

  1. Always place the screws you remove with their respective slots, this will prevent you from trying to insert a screw that is too big and causing internal damage. (A magnetic mat can help with this!)

  2. Because this is a smaller device and you will be interacting with some of the circuit boards directly, you may wish to wear an anti-static wrist wrap to prevent damage.

  3. Ribbon cables (named due to their shape) are quite delicate and should be handled gently if possible. We will be sure to warn you when dealing with these.

Otherwise, this guide will mainly be unscrewing screws.

What you need

Step 1

              Panasonic Lumix DMC-FX37 Disassembly
  • Remove both of the 3 mm screws on the bottom of the camera connected to the side panel.

Remove both of the 3 mm screws on the bottom of the camera connected to the side panel.

1024

Step 2

  • Remove the remaining 3 mm screw holding on the side panel and remove the panel entirely.

Remove the remaining 3 mm screw holding on the side panel and remove the panel entirely.

Step 3

  • On the opposite side of the camera, remove the two 3 mm screws.
  • Remove the bottom side panel and place it with its respective 3 mm screw.

On the opposite side of the camera, remove the two 3 mm screws.

Remove the bottom side panel and place it with its respective 3 mm screw.

Step 4

  • Remove the front panel (the panel around the lens casing) from the camera.
  • Remove the two ribbon cables connected to the back panel (the panel this the LCD screen) by lifting up on their respective tabs and gently pulling out the cord.
  • Caution: When removing the back panel, the two ribbon cables are relatively delicate and must both be disconnected before the panel can be entirely removed.
  • Remove the back panel from the camera.

Remove the front panel (the panel around the lens casing) from the camera.

Remove the two ribbon cables connected to the back panel (the panel this the LCD screen) by lifting up on their respective tabs and gently pulling out the cord.

Caution: When removing the back panel, the two ribbon cables are relatively delicate and must both be disconnected before the panel can be entirely removed.

Remove the back panel from the camera.

Step 5

  • Remove the top control panel (connected to the flash battery) from the camera.
  • The top control panel is connected to the rest of the camera by a delicate multi-pin plug. Be careful as to not bend the pins!

Remove the top control panel (connected to the flash battery) from the camera.

The top control panel is connected to the rest of the camera by a delicate multi-pin plug. Be careful as to not bend the pins!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Jackson O'DOnnell

Member since: 01/30/2018

283 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Baylor, Team S2-G3, Johnson Spring 2018                        

                                                  Member of Baylor, Team S2-G3, Johnson Spring 2018 



                    BU-JOHNSON-S18S2G3                     


                                            3 Members                     


                                            6 Guides authored