Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

  • Screen
  • 7 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackPanasonic Lumix DMC-FX9

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Screen
  • Make sure the power is off by making sure the switch is to the right. The power switch can be found on the top side of the camera.

Make sure the power is off by making sure the switch is to the right. The power switch can be found on the top side of the camera.

1024

Step 2

  • Use the Philips #00 Screwdriver on the screw on the left side of the camera.
  • There is another screw on the underside of the camera that is part of the left cover.

Use the Philips #00 Screwdriver on the screw on the left side of the camera.

There is another screw on the underside of the camera that is part of the left cover.

Step 3

  • Use the Philips #00 Screwdriver to remove the two screws on the right cover of the camera.

Use the Philips #00 Screwdriver to remove the two screws on the right cover of the camera.

Step 4

  • Use the Philips #00 Screwdriver to remove the screws on the bottom side of the camera.
  • Make sure to grasp the camera because these are the last two screws that hold the camera in place.
  • Carefully place the opening tool between the two covers and gently apply force upward to separate the covers.

Use the Philips #00 Screwdriver to remove the screws on the bottom side of the camera.

Make sure to grasp the camera because these are the last two screws that hold the camera in place.

Carefully place the opening tool between the two covers and gently apply force upward to separate the covers.

Step 5

  • There are two digitizer cables that connect the LCD Screen to the camera motherboard.
  • The digitizer cables are held down by retaining flats.
  • Carefully use the opening tool to push the retaining flats upward to allow the digitizer cables to disconnect.

There are two digitizer cables that connect the LCD Screen to the camera motherboard.

The digitizer cables are held down by retaining flats.

Carefully use the opening tool to push the retaining flats upward to allow the digitizer cables to disconnect.

Step 6

  • Carefully use the opening tool to remove the LCD Screen from the glass frame.

Carefully use the opening tool to remove the LCD Screen from the glass frame.

Step 7

  • Carefully use the opening tool to seperate the screen from the frame.

Carefully use the opening tool to seperate the screen from the frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Ever Escobar

Member since: 02/08/2018

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       University of North Texas, Team S6-G1, Thomas Spring 2018                        

                                                  Member of University of North Texas, Team S6-G1, Thomas Spring 2018 



                    UNT-THOMAS-S18S6G1                     


                                            4 Members                     


                                            9 Guides authored