Difficulty

Moderate

Steps

5

Time Required

                          30 minutes

Sections

2

  • Back Casing
  • 3 steps
  • Screen
  • 2 steps

Flags

0

  • BackPanasonic Lumix DMC-ZS35

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before you replace your LCD screen, take a look at this Troubleshooting Guide to see if there is a simpler solution to your problem. Before you begin, make sure to turn the camera off and remove the battery.

What you need

Step 1

              Back Casing
  • Remove the six 4mm screws located on the side and bottom of the camera casing using a Phillips #000 screwdriver.

Remove the six 4mm screws located on the side and bottom of the camera casing using a Phillips #000 screwdriver.

1024

Step 2

  • Use a plastic opening tool to carefully separate the back casing from the main body of the camera. It’s advised to run along the entire “seam” of the casing and the camera with the tool to ensure full separation.

Use a plastic opening tool to carefully separate the back casing from the main body of the camera. It’s advised to run along the entire “seam” of the casing and the camera with the tool to ensure full separation.

Step 3

  • Gently pry apart the back casing from the body of the camera. It’s recommended to apply as minimal force as is necessary to prevent unintended damage to the camera or the casing.

Gently pry apart the back casing from the body of the camera. It’s recommended to apply as minimal force as is necessary to prevent unintended damage to the camera or the casing.

Step 4

              Screen
  • Unscrew the four 3mm screws holding the LCD screen hinge in place using a Phillips #000 screwdriver.

Unscrew the four 3mm screws holding the LCD screen hinge in place using a Phillips #000 screwdriver.

Step 5

  • Gently pull LCD screen ribbon cable from internal port to disconnect the screen and prevent unwanted damage.
  • Lift the freed LCD screen from the base camera to complete the process.

Gently pull LCD screen ribbon cable from internal port to disconnect the screen and prevent unwanted damage.

Lift the freed LCD screen from the base camera to complete the process.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Rachel Hughes

Member since: 01/31/2020

688 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UW Stout, Team S1-G2, Schneider-Bateman Spring 2020                        

                                                  Member of UW Stout, Team S1-G2, Schneider-Bateman Spring 2020 



                    UWSTOUT-SCHNEIDER-BATEMAN-S20S1G2                     


                                            4 Members                     


                                            10 Guides authored