Panasonic Lumix Dmc Zs60 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 minutes            

Sections

2

• Battery
• 3 steps
• LCD Screen
• 5 steps

Flags

0

• BackPanasonic Lumix DMC-ZS60

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

A functional LCD screen provides the user ability to look and edit pictures taken. An LCD screen could become nonfunctional over time or if the camera is mistreated.

Make sure that your device is powered off and not charging before attempting to replace your LCD screen.

What you need

Step 1

              Battery               

• Use your finger to slide the black latch from the locked position to the open position on the memory card/battery door. This will open the door of the camera.

Use your finger to slide the black latch from the locked position to the open position on the memory card/battery door. This will open the door of the camera.

1024

Step 2

• Push up the black tab on the right-hand-side to spring release the battery.

Push up the black tab on the right-hand-side to spring release the battery.

Step 3

• Remove the battery by sliding it out from the camera.

Remove the battery by sliding it out from the camera.

Step 4

              LCD Screen               

• Using the Phillips #000 Screwdriver, unscrew six 3mm screws. There are two screws located on three sides excluding the top.

Using the Phillips #000 Screwdriver, unscrew six 3mm screws. There are two screws located on three sides excluding the top.

Step 5

• Pry off back casing and set aside.

Pry off back casing and set aside.

Step 6

• Pull the right side control dial circuit board up.
• Use tweezers to pry up the white retaining flap and gently pull the circuit board out.

Pull the right side control dial circuit board up.

Use tweezers to pry up the white retaining flap and gently pull the circuit board out.

Step 7

• Flip the LCD screen to the left.
• Unscrew the two 3mm on the top right side using the Phillips #000 Screwdriver.
• Lift the gray plate cover off.

Flip the LCD screen to the left.

Unscrew the two 3mm on the top right side using the Phillips #000 Screwdriver.

Lift the gray plate cover off.

Step 8

• Use tweezers to pry up the black retaining flat and gently pull to free the LCD screen from the device.

Use tweezers to pry up the black retaining flat and gently pull to free the LCD screen from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Audrey Arnold                     

Member since: 01/16/2020

347 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S7-G10, Rauch Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S7-G10, Rauch Spring 2020 



                    ERAU-RAUCH-S20S7G10                     


                                            3 Members                     


                                            9 Guides authored