Panasonic Sa Ht810V Vhs Drive Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

VHS Drive
7 steps

Flags

BackPanasonic SA-HT810V
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              VHS Drive

With the front display of the device facing you, rotate the device 90 degrees counter clockwise.
Now rotate the device 180 degrees and remove the second screw.
Remove the screw that is on the right side of the panel facing you.
All screws will need to be removed with a phillips head screwdriver.

With the front display of the device facing you, rotate the device 90 degrees counter clockwise.

Now rotate the device 180 degrees and remove the second screw.

Remove the screw that is on the right side of the panel facing you.

All screws will need to be removed with a phillips head screwdriver.

1024

Step 2

Rotate the device so that the back faces you.
With a phillips heat screwdriver, locate and remove the four screws highlighted by the red circles in image one.

Rotate the device so that the back faces you.

With a phillips heat screwdriver, locate and remove the four screws highlighted by the red circles in image one.

Step 3

Before removing cover make sure that the back of the device is facing you.
Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.

Before removing cover make sure that the back of the device is facing you.

Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.

Step 4

Pull up the two tabs on top
Pull the the three tabs on the side there is one on the left and two and the right side of the device when it is facing you.
Depress the four tabs on the bottom of the device.

Pull up the two tabs on top

Pull the the three tabs on the side there is one on the left and two and the right side of the device when it is facing you.

Depress the four tabs on the bottom of the device.

Step 5

Carefully pull off the front panel of the device.
The front is attached to the device with cables so be careful when removing.

Carefully pull off the front panel of the device.

The front is attached to the device with cables so be careful when removing.

Step 6

With the device front facing you remove the six screws with a phillips head screwdriver around the VHS drive.

With the device front facing you remove the six screws with a phillips head screwdriver around the VHS drive.

Step 7

Remove the three cables attaching the VHS to the Mother Board.
Carefully pull the VHS drive out of the device and follow the steps in reverse to place the new one in.

Remove the three cables attaching the VHS to the Mother Board.

Carefully pull the VHS drive out of the device and follow the steps in reverse to place the new one in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 8 other contributors

                    Nathan Cheadle

Member since: 04/15/2010

161 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 16-5, Maness Spring 2010                        

                                                  Member of Cal Poly, Team 16-5, Maness Spring 2010 



                    CPSU-MANESS-S10S16G5                     


                                            4 Members                     


                                            7 Guides authored

What you need#

Team#

What you need

Team