Difficulty
Moderate
Steps
9
Time Required
Suggest a time??
Sections
1
- Screen
- 9 steps
Flags
2
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackPandigital Novel PRD07T10WWH7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Remove the back panel by sliding it downwards and pushing in slightly.
Remove the back panel by sliding it downwards and pushing in slightly.
1024
Step 2
- Pry off the second white panel, removing two clips underneath.
- Start from the middle, and then work on the sides. The sides may be difficult to remove, so try to focus on one side and work your way around.
Pry off the second white panel, removing two clips underneath.
Start from the middle, and then work on the sides. The sides may be difficult to remove, so try to focus on one side and work your way around.
Step 3
- Using a Phillips #0 bit, remove the 12 4mm screws on the outer area of the gray area exposed by removing the back panels.
Using a Phillips #0 bit, remove the 12 4mm screws on the outer area of the gray area exposed by removing the back panels.
Step 4
- Carefully pry the back of the device from the front panel and motherboard. There are a series of clips holding them together that need to be separated.
Carefully pry the back of the device from the front panel and motherboard. There are a series of clips holding them together that need to be separated.
Step 5
- Now, lift up the gray piece, unplug the battery connector, so the gray piece will come free from the rest of the device.
Now, lift up the gray piece, unplug the battery connector, so the gray piece will come free from the rest of the device.
Step 6
- Use the tip of your plastic spudger or your fingernail to flip up the long retaining flap. The longer, gold ribbon cable can now be pulled out safely.
Use the tip of your plastic spudger or your fingernail to flip up the long retaining flap. The longer, gold ribbon cable can now be pulled out safely.
Step 7
- Use the tip of your plastic spudger or your fingernail to flip up the shorter retaining flap. The smaller gold ribbon cable can now be pulled out safely.
Use the tip of your plastic spudger or your fingernail to flip up the shorter retaining flap. The smaller gold ribbon cable can now be pulled out safely.
Step 8
- Starting from the side of the device, lift the motherboard off of the plastic standoffs.
- You will need to peel both speakers off of the device’s plastic frame.
Starting from the side of the device, lift the motherboard off of the plastic standoffs.
You will need to peel both speakers off of the device’s plastic frame.
Step 9
- With the screen facing up, use a plastic opening tool along the sides of the screen to pry it away from the motherboard.
- There are six adhesive pads holding the display in place.
With the screen facing up, use a plastic opening tool along the sides of the screen to pry it away from the motherboard.
There are six adhesive pads holding the display in place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Samuel Carey
Member since: 10/19/2016
401 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team 3-7, Isaacson Fall 2016
Member of UMass Dartmouth, Team 3-7, Isaacson Fall 2016
UMASSD-ISAACSON-F16S3G7
3 Members
10 Guides authored
