Pandigital Novel Prd07T10Wwh7 Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Speaker
9 steps

Flags

BackPandigital Novel PRD07T10WWH7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Speaker

Remove the back panel by sliding it downwards and pushing in slightly.

Remove the back panel by sliding it downwards and pushing in slightly.

1024

Step 2

Pry off the second white panel, removing two clips underneath.
Start from the middle, and then work on the sides. The sides may be difficult to remove, so try to focus on one side and work your way around.

Pry off the second white panel, removing two clips underneath.

Start from the middle, and then work on the sides. The sides may be difficult to remove, so try to focus on one side and work your way around.

Step 3

Using a Phillips #0 bit, remove the 12 4mm screws on the outer area of the gray area exposed by removing the back panels.

Using a Phillips #0 bit, remove the 12 4mm screws on the outer area of the gray area exposed by removing the back panels.

Step 4

Carefully pry the back of the device from the front panel and motherboard. There are a series of clips holding them together that need to be separated.

Carefully pry the back of the device from the front panel and motherboard. There are a series of clips holding them together that need to be separated.

Step 5

Now, lift up the gray piece, unplug the battery connector, so the gray piece will come free from the rest of the device.

Now, lift up the gray piece, unplug the battery connector, so the gray piece will come free from the rest of the device.

Step 6

Use the tip of your plastic spudger or your fingernail to flip up the long retaining flap. The longer, gold ribbon cable can now be pulled out safely.

Use the tip of your plastic spudger or your fingernail to flip up the long retaining flap. The longer, gold ribbon cable can now be pulled out safely.

Step 7

Use the tip of your plastic spudger or your fingernail to flip up the shorter retaining flap. The smaller gold ribbon cable can now be pulled out safely.

Use the tip of your plastic spudger or your fingernail to flip up the shorter retaining flap. The smaller gold ribbon cable can now be pulled out safely.

Step 8

Starting from the side of the device, lift the motherboard off of the plastic standoffs.
You will need to peel both speakers off of the device’s plastic frame.

Starting from the side of the device, lift the motherboard off of the plastic standoffs.

You will need to peel both speakers off of the device’s plastic frame.

Step 9

Unplug the speakers from the connectors on the motherboard.

Unplug the speakers from the connectors on the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Samuel Carey

Member since: 10/19/2016

401 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 3-7, Isaacson Fall 2016                        

                                                  Member of UMass Dartmouth, Team 3-7, Isaacson Fall 2016 



                    UMASSD-ISAACSON-F16S3G7                     


                                            3 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team