Difficulty

Easy

Steps

8

Time Required

                          15 - 20 minutes

Sections

2

  • Propeller and Gear
  • 4 steps
  • Motor
  • 4 steps

Flags

0

  • BackParrot AR.Drone 2.0

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

AR.Drone 2.0 spare parts and mounting tools are available from several Parrot retailers.

What you need

Video Overview

Step 1

              Propeller and Gear
  • Remove the foam body.

Remove the foam body.

1024

Step 2

  • Disconnect the battery by pulling the two red wires apart.
  • Remove the battery by releasing the battery retaining straps.

Disconnect the battery by pulling the two red wires apart.

Remove the battery by releasing the battery retaining straps.

Step 3

  • Remove the small retaining clip using a plastic opening tool.
  • Be careful as these clips can fly off and can be difficult to find.

Remove the small retaining clip using a plastic opening tool.

Be careful as these clips can fly off and can be difficult to find.

Step 4

  • The propeller, gear, and rod can be removed by simply lifting them off the motor.

The propeller, gear, and rod can be removed by simply lifting them off the motor.

Step 5

              Motor
  • Disconnect the connector at the bottom of the motor assembly.

Disconnect the connector at the bottom of the motor assembly.

Step 6

  • Remove the three 5mm screws on the top of the motor assembly with a PH00 bit.

Remove the three 5mm screws on the top of the motor assembly with a PH00 bit.

Step 7

  • Remove the three 5mm screws on the bottom again using a PH00 bit.
  • The three screws from the top are different from the three screws on the bottom.

Remove the three 5mm screws on the bottom again using a PH00 bit.

The three screws from the top are different from the three screws on the bottom.

Step 8

  • Carefully wiggle out the motor assembly out of the arm.

Carefully wiggle out the motor assembly out of the arm.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 10 other contributors 


                    David Hoyt

Member since: 04/09/2010

3,921 Reputation

                                      43 Guides authored                  



                       Badges:
                       28







                                                        +25 more badges

Team

                       Cal Poly, Team 25-89, Amido Spring 2010                        

                                                  Member of Cal Poly, Team 25-89, Amido Spring 2010 



                    CPSU-AMIDO-S10S25G89                     


                                            4 Members                     


                                            63 Guides authored

dbksoft - Apr 7, 2017

Reply

are the motors different on each side?

Steven Maloney - Aug 13, 2017

I need to know this also. replaced cross.member but did not put motors in original spots now my drone goes crazy and erratic