Difficulty

Easy

Steps

9

Time Required

                          3 minutes

Sections

3

  • Battery
  • 3 steps
  • Styrofoam Nose
  • 3 steps
  • GPS Board
  • 3 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackParrot Bebop Drone

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Begin by removing the velcro strap around the battery.

Begin by removing the velcro strap around the battery.

1024

Step 2

  • While holding onto the nose, gently pull the battery away from the nose.

While holding onto the nose, gently pull the battery away from the nose.

Step 3

  • Once the battery is separated from the nose, push down on the connector and pull the battery away from the connector.

Once the battery is separated from the nose, push down on the connector and pull the battery away from the connector.

Step 4

              Styrofoam Nose
  • Remove the two 7mm T5 torx screws using a screwdriver. There is one located on each side.

Remove the two 7mm T5 torx screws using a screwdriver. There is one located on each side.

Step 5

  • Take the metal spudger, to remove the double stick tape from the foam.

Take the metal spudger, to remove the double stick tape from the foam.

Step 6

  • Remove the styrofoam nose from over the drone’s camera by sliding it towards the front of the drone at an angle.

Remove the styrofoam nose from over the drone’s camera by sliding it towards the front of the drone at an angle.

Step 7

              GPS Board
  • Remove the cable from the top of the GPS module.

Remove the cable from the top of the GPS module.

Step 8

  • Remove the two 6mm T5 torx screws holding the GPS module. There is one screw on each side.
  • Remove the 4mm T5 Screw holding the GPS Module.

Remove the two 6mm T5 torx screws holding the GPS module. There is one screw on each side.

Remove the 4mm T5 Screw holding the GPS Module.

Step 9

  • Remove the GPS board by lifting it off of the metal frame.

Remove the GPS board by lifting it off of the metal frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors 


                    Austin

Member since: 02/02/2017

185 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UW Tacoma, Team 1-3, Rose Winter 2017                        

                                                  Member of UW Tacoma, Team 1-3, Rose Winter 2017 



                    UWT-ROSE-W17S1G3                     


                                            4 Members                     


                                            5 Guides authored

Albert - Oct 1, 2020

Reply

With voice driving directions maps <a href=“https://play.google.com/store/apps/detai…

“>GPS Voice Nevigation with speed limits with speaking ,user can get accurate gps coordinates for car GPS navigation.In gps driving guide 2019 users can listen to voice input for voice navigation which gives out all of the audio instructions for direction gps towards destination point on the maps