Difficulty
Easy
Steps
6
Time Required
1 minute
Sections
2
- Battery
- 3 steps
- Styrofoam Nose
- 3 steps
Flags
0
BackParrot Bebop Drone
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Begin by removing the velcro strap around the battery.
Begin by removing the velcro strap around the battery.
1024
Step 2
- While holding onto the nose, gently pull the battery away from the nose.
While holding onto the nose, gently pull the battery away from the nose.
Step 3
- Once the battery is separated from the nose, push down on the connector and pull the battery away from the connector.
Once the battery is separated from the nose, push down on the connector and pull the battery away from the connector.
Step 4
Styrofoam Nose
- Remove the two 7mm T5 torx screws using a screwdriver. There is one located on each side.
Remove the two 7mm T5 torx screws using a screwdriver. There is one located on each side.
Step 5
- Take the metal spudger, to remove the double stick tape from the foam.
Take the metal spudger, to remove the double stick tape from the foam.
Step 6
- Remove the styrofoam nose from over the drone’s camera by sliding it towards the front of the drone at an angle.
Remove the styrofoam nose from over the drone’s camera by sliding it towards the front of the drone at an angle.
To reassemble your device, follow these intructions in reverse order
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Jamuna Budhathoki
Member since: 02/03/2017
137 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
UW Tacoma, Team 1-3, Rose Winter 2017
Member of UW Tacoma, Team 1-3, Rose Winter 2017
UWT-ROSE-W17S1G3
4 Members
5 Guides authored
