Difficulty
Easy
Steps
7
Time Required
1 minute
Sections
2
- Rudder
- 3 steps
- Lever Arm
- 4 steps
Flags
0
BackParrot Hydrofoil Orak
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rudder
- Place the boat so that the front faces to the right.
Place the boat so that the front faces to the right.
1024
Step 2
- Remove the far left 1cm screw using a T8 screwdriver.
Remove the far left 1cm screw using a T8 screwdriver.
Step 3
- Remove the rudder.
Remove the rudder.
Step 4
Lever Arm
- Remove the four remaining 1cm screws with the T8 screw driver.
Remove the four remaining 1cm screws with the T8 screw driver.
Step 5
- Lift up on the plastic piece that is securing the lever arm.
Lift up on the plastic piece that is securing the lever arm.
Step 6
- Flip the plastic part upside down to reveal where the lever arm sits.
Flip the plastic part upside down to reveal where the lever arm sits.
Step 7
- Lift the lever arm from the slot it is in and slide off of the end of the plastic piece that was holding it to the boat.
Lift the lever arm from the slot it is in and slide off of the end of the plastic piece that was holding it to the boat.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Justin Connerly
Member since: 10/06/2016
273 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 20-2, Livingston Fall 2016
Member of Cal Poly, Team 20-2, Livingston Fall 2016
CPSU-LIVINGSTON-F16S20G2
4 Members
5 Guides authored
