Difficulty
Moderate
Steps
3
Time Required
5 minutes
Sections
1
- Earpads
- 3 steps
Flags
0
BackPDP Afterglow Fener
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Earpads
- Start by removing the right ear pad. Be careful not to pull too hard as it may rip.
- Gently tug on the pad until it comes free from the slot, which is marked by the red square.
Start by removing the right ear pad. Be careful not to pull too hard as it may rip.
Gently tug on the pad until it comes free from the slot, which is marked by the red square.
1024
Step 2
- Next, repeat step 1 with the left ear pad this time.
Next, repeat step 1 with the left ear pad this time.
Step 3
- Your headset should now look like this, with the two ear pads removed.
- You may now continue with a more complex inner headset repair or replace the ear pads by sliding new ones into the slots.
Your headset should now look like this, with the two ear pads removed.
You may now continue with a more complex inner headset repair or replace the ear pads by sliding new ones into the slots.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Thomas Williams
Member since: 10/22/2015
512 Reputation
4 Guides authored
Badges:
14
+11 more badges
Team
UMass Dartmouth, Team 5-3, Gulbrandsen Fall 2015
Member of UMass Dartmouth, Team 5-3, Gulbrandsen Fall 2015
UMASSD-GULBRANDSEN-F15S5G3
3 Members
10 Guides authored
peterkd2010 - Dec 7, 2019
Reply
The problem is not pulling off the earpad, but putting it on again!