Pdp Afterglow Wired Xbox 360 Controller Button Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          20 minutes            

Sections

2

• Case
• 3 steps
• Button
• 2 steps

Flags

0

• BackPDP Afterglow Wired Xbox 360 Controller

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Case               

• Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

1024

Step 2

• Using a plastic opening tool, pry the back cover from the front.
• The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Using a plastic opening tool, pry the back cover from the front.

The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Step 3

• Remove the top cover from the bottom and place next to each other.

Remove the top cover from the bottom and place next to each other.

Step 4

              Button               

• Remove the rubber button covers from the A, B, X, and Y buttons.

Remove the rubber button covers from the A, B, X, and Y buttons.

Step 5

• Push up on the buttons from the front and pull them out from the back.

Push up on the buttons from the front and pull them out from the back.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    Joi Officer                     

Member since: 09/17/2015

247 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       IUPUI, Team 3-1, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-1, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G1                     


                                            4 Members                     


                                            5 Guides authored                     

Elijah Douglas - Apr 23, 2016

Reply

What about removing the Dpad? i really need help.

Christopher Mali-Martinez - Oct 16, 2017

Reply

I’m sorry but, I have to say that the reassembly process is harder than simply ‘follow the instructions in reverse’; if you try and place the half with the buttons, the buttons fall out or end up misaligned ; and if you use the other half, the rubber covers and the tumblers will fall out.

Again, this guild comes off a little too simple, there’s more to it.

Tyler Anderson - Apr 16, 2022

the circuit board comes off the other half. You can stack them very easily. You’re simply incorrect.