Pdp Afterglow Wired Xbox 360 Controller Cable Replacement Repair Guide

Difficulty

Difficult

Steps

7

Time Required

                          1 hour            

Sections

2

• Case
• 3 steps
• Cable
• 4 steps

Flags

0

• BackPDP Afterglow Wired Xbox 360 Controller

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Case               

• Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

1024

Step 2

• Using a plastic opening tool, pry the back cover from the front.
• The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Using a plastic opening tool, pry the back cover from the front.

The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Step 3

• Remove the top cover from the bottom and place next to each other.

Remove the top cover from the bottom and place next to each other.

Step 4

              Cable               

• Remove the logic board by lifting up on the logic board and pulling out.

Remove the logic board by lifting up on the logic board and pulling out.

Step 5

• The cable connects to the logic board with a white connector. Above the right joystick, there are four solder pins labeled GND, VCC, DM, and DP.

The cable connects to the logic board with a white connector. Above the right joystick, there are four solder pins labeled GND, VCC, DM, and DP.

Step 6

• The soldering iron is very hot and can harm you or the device if used incorrectly.
• Desolder the four pins.

The soldering iron is very hot and can harm you or the device if used incorrectly.

Desolder the four pins.

Step 7

• Using your new cable, solder the white connector to the logic board. Be sure to have the cables facing towards the inside of the logic board.

Using your new cable, solder the white connector to the logic board. Be sure to have the cables facing towards the inside of the logic board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Jayson Norcross                     

Member since: 09/17/2015

268 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       IUPUI, Team 3-1, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-1, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G1                     


                                            4 Members                     


                                            5 Guides authored                     

Aaron English - Apr 2, 2016

Reply

where can I find a replacement cable to perform this precedure with?

sokratis162 - Sep 12, 2016

yes!! i would like to know too.. i have been searching for long time for that cable

Wayne - Apr 1, 2018

Android cable

Wayne - Apr 1, 2018

Reply

U can use a old Android cable