Difficulty
Easy
Steps
3
Time Required
5 - 10 minutes
Sections
1
- Case
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackPDP Afterglow Wired Xbox 360 Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Case
- Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.
Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.
1024
Step 2
- Using a plastic opening tool, pry the back cover from the front.
- The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.
Using a plastic opening tool, pry the back cover from the front.
The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.
Step 3
- Remove the top cover from the bottom and place next to each other.
Remove the top cover from the bottom and place next to each other.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Aaron
Member since: 09/14/2015
103 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
IUPUI, Team 3-1, Harley Fall 2015
Member of IUPUI, Team 3-1, Harley Fall 2015
IUPUI-HARLEY-F15S3G1
4 Members
5 Guides authored
