Pdp Afterglow Wired Xbox 360 Controller Leds Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          30 minutes

Sections

Case
3 steps
LEDs
3 steps

Flags

BackPDP Afterglow Wired Xbox 360 Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Case

Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.

1024

Step 2

Using a plastic opening tool, pry the back cover from the front.
The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Using a plastic opening tool, pry the back cover from the front.

The covers should separate without needing a plastic opening tool, but in some cases you may need to use it.

Step 3

Remove the top cover from the bottom and place next to each other.

Remove the top cover from the bottom and place next to each other.

Step 4

              LEDs

Remove the logic board from the controller casing by lifting up and pulling out.

Remove the logic board from the controller casing by lifting up and pulling out.

Step 5

Locate the LED (s) that needs to be replaced.
Once the LED has been located, flip the logic board to the other side and locate the pins associated with the LED that needs to be replaced.

Locate the LED (s) that needs to be replaced.

Once the LED has been located, flip the logic board to the other side and locate the pins associated with the LED that needs to be replaced.

Step 6

Desolder the LED from the logic board.
The soldering iron is very hot and can harm you or the device if used improperly.

Desolder the LED from the logic board.

The soldering iron is very hot and can harm you or the device if used improperly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Joi Officer

Member since: 09/17/2015

247 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 3-1, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-1, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G1                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team