Difficulty

Easy

Steps

5

Time Required

                          45 minutes

Sections

1

  • Input Jack
  • 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackPeavy XM4

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove Front panel
  • There are two screws at the top and two at the bottom

There are two screws at the top and two at the bottom

1024

Step 2

              Remove dial fixings
  • All of the dials have a rubber cover and a nut, these need to be removed from all of the dials. The Jack inputs also have a nut holding them in place, remove these also.

All of the dials have a rubber cover and a nut, these need to be removed from all of the dials. The Jack inputs also have a nut holding them in place, remove these also.

Step 3

              Remove input jack
  • Remove the input jack by desoldering the pins on the other side of the board, you may want to use a solder remover tool to make it easier.

Remove the input jack by desoldering the pins on the other side of the board, you may want to use a solder remover tool to make it easier.

Step 4

              Solder new jack
  • Solder the new jack in place, the jack i used had an extra pin but was not needed. i ended up bending it out of the way and it all still works.

Solder the new jack in place, the jack i used had an extra pin but was not needed. i ended up bending it out of the way and it all still works.

Step 5

              Re-assemble
  • Once the jack or jacks have been replaced simply re-assemble by working backwards, remember that the dials each have a screw and a topper. when putting the toppers back on make sure the dials are turned to the minimum value and line them up to avoid confusion when being used.

Once the jack or jacks have been replaced simply re-assemble by working backwards, remember that the dials each have a screw and a topper. when putting the toppers back on make sure the dials are turned to the minimum value and line them up to avoid confusion when being used.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Josh Walford

Member since: 01/12/2018

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       2