Pebble Steel Failure Of Screen Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

• Pebble Steel failure of screen
• 5 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackPebble Steel

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Step 1

              Disassemble Strap               

• The first step is to remove the strap. To do this, we will use a 1.5mm flathead screwdriver.

The first step is to remove the strap. To do this, we will use a 1.5mm flathead screwdriver.

1024

Step 2

              Remove back cover               

• We will disassemble the cover of the clock using a screwdriver T-5, and being careful with the rubber gasket that has, we will remove the metallic cover.

We will disassemble the cover of the clock using a screwdriver T-5, and being careful with the rubber gasket that has, we will remove the metallic cover.

Step 3

              Find and cut a soft rubber               

• In this step we will look for a dissipative silicone of those that carry the laptops for the microprocessor. If you do not have it, you could use a piece of soft rubber that does not exceed 0.65mm thick.

In this step we will look for a dissipative silicone of those that carry the laptops for the microprocessor. If you do not have it, you could use a piece of soft rubber that does not exceed 0.65mm thick.

Step 4

              Place rubber               

• We will place this rubber in the lower right corner of the watch, on the vibrator and the connector of the screen. The golden connector on the left must be left free since it makes contact with the lid.

We will place this rubber in the lower right corner of the watch, on the vibrator and the connector of the screen. The golden connector on the left must be left free since it makes contact with the lid.

Step 5

              Close and READY !!!!               

• Finally we assemble the clock reversing the steps. ‘++ It is important when placing the cover to put first the two screws above and then the two screws below.’ (This forces the entire internal chassis, thus exerting a pressure on the rubber contact of the screen.)

Finally we assemble the clock reversing the steps. ‘++ It is important when placing the cover to put first the two screws above and then the two screws below.’ (This forces the entire internal chassis, thus exerting a pressure on the rubber contact of the screen.)

For reassembling your device, follow these instructions in the reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             


        These translators are helping us fix the world!      Want to contribute?      Start translating › 

Special thanks to these translators:

100%

Corey Meyer

Mr. Bean

Nick Burgnon

Author

                                      with 1 other contributor 

                    Marcos Garcia                     

Member since: 03/29/2016

175 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges