Difficulty

Moderate

Steps

12

Time Required

                          10 minutes

Sections

3

  • Screen Cover
  • 4 steps
  • Screen
  • 3 steps
  • Circuit Board
  • 5 steps

Flags

0

  • BackPebble Time

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen Cover
  • Lay the watch flat on your workstation.

Lay the watch flat on your workstation.

1024

Step 2

  • Use the metal spudger to carefully pull apart the screen cover from the case.
  • Replace the metal spudger with a plastic opening tool to hold the cover open.

Use the metal spudger to carefully pull apart the screen cover from the case.

Replace the metal spudger with a plastic opening tool to hold the cover open.

Step 3

  • Use the metal spudger tool to carefully loosen the rest of the cover.

Use the metal spudger tool to carefully loosen the rest of the cover.

Step 4

  • Carefully, pull apart the cover with the plastic opening tool.

Carefully, pull apart the cover with the plastic opening tool.

Step 5

              Screen
  • Insert metal spudger into the side of the screen shown in the picture.

Insert metal spudger into the side of the screen shown in the picture.

Step 6

  • Use the metal spudger to pry the screen up.

Use the metal spudger to pry the screen up.

Step 7

  • Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.
  • Disconnect the screen from the circuit board.

Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.

Disconnect the screen from the circuit board.

Step 8

              Circuit Board
  • Keep the watch flat on your workstation.

Keep the watch flat on your workstation.

Step 9

  • Locate the three screws on the circuit board.
  • Remove using the J000 Philips head screwdriver.

Locate the three screws on the circuit board.

Remove using the J000 Philips head screwdriver.

Step 10

  • Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool.
  • Move apart the connector to expose the fourth screw.

Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool.

Move apart the connector to expose the fourth screw.

Step 11

  • Remove the final screw from the circuit board with a J000 Philips head screwdriver.

Remove the final screw from the circuit board with a J000 Philips head screwdriver.

Step 12

  • Turn the watch to the side and use the plastic opening tool to lift up the circuit board.
  • Remove the circuit board from the case.

Turn the watch to the side and use the plastic opening tool to lift up the circuit board.

Remove the circuit board from the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Nicolas Hempe

Member since: 02/15/2017

1,348 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       USF Tampa, Team 1-3, Sullivan Spring 2017                        

                                                  Member of USF Tampa, Team 1-3, Sullivan Spring 2017 



                    USFT-SULLIVAN-S17S1G3                     


                                            4 Members                     


                                            7 Guides authored