Pentax Optio Wg 3 Gps Menu Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 30 minutes

Sections

Menu Button
5 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

Better Introduction

Improve this guide by completing or revising its introduction.

BackPentax Optio WG-3 GPS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Menu Button

Remove the 6, 5 mm screws, 4 on each corner and 2 on the sides of the device.
One of the side screws is hidden under the top lining of the device.The lining is glued down to the device so you will have to peel the lining back using tweezers. After you are finished with your work you will have to use glue or adhesive to re-stick the lining back to the device.

Remove the 6, 5 mm screws, 4 on each corner and 2 on the sides of the device.

One of the side screws is hidden under the top lining of the device.The lining is glued down to the device so you will have to peel the lining back using tweezers. After you are finished with your work you will have to use glue or adhesive to re-stick the lining back to the device.

1024

Step 2

With the small plastic pry tool lift the back of the camera off carefully.
Open the device slowly and be aware of a few flex cables that connect the mother board to the screen. These will have to be carefully disconnected before the top part is removed.

With the small plastic pry tool lift the back of the camera off carefully.

Open the device slowly and be aware of a few flex cables that connect the mother board to the screen. These will have to be carefully disconnected before the top part is removed.

Step 3

Remove the 8, 2 mm screws from each corner of the metal button pad cover.
Using tweezers remove the metal cover.
The smaller Metal square piece on the device.

Remove the 8, 2 mm screws from each corner of the metal button pad cover.

Using tweezers remove the metal cover.

The smaller Metal square piece on the device.

Step 4

Remove the 1, 2 mm screw near the edge of the device.

Remove the 1, 2 mm screw near the edge of the device.

Step 5

Now using tweezers, remove the menu button from its place.
After removing the button you can replace the entire component.

Now using tweezers, remove the menu button from its place.

After removing the button you can replace the entire component.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Allison Merdian

Member since: 03/05/2015

422 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Sam Houston State, Team 11-4, Blackburne Winter 2015                        

                                                  Member of Sam Houston State, Team 11-4, Blackburne Winter 2015 



                    SHSU-BLACKBURNE-W15S11G4                     


                                            2 Members                     


                                            8 Guides authored

Slice and Dice#

Better Introduction#

What you need#

Team#

Slice and Dice

Better Introduction

What you need

Team