Petnet Smartfeeder Sf10E 12 Pin Connector Replacement Repair Guide

Difficulty

Easy

Steps

7

Time Required

                          8 - 10 minutes            

Sections

1

• 12 Pin Connector
• 7 steps

Flags

0

• BackPetnet SmartFeeder SF10E

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              12 Pin Connector               

• Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

1024

Step 2

• Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.

Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.

Step 3

• Remove the black plastic gasket from the top of the SmartFeeder by placing your fingers on the side of it and lifting up.
• It should come off easily.

Remove the black plastic gasket from the top of the SmartFeeder by placing your fingers on the side of it and lifting up.

It should come off easily.

Step 4

• Flip over the SmartFeeder by using both hands.
• Partially open the outer case of the SmartFeeder by wedging an iFixit Opening Tool on each side.

Flip over the SmartFeeder by using both hands.

Partially open the outer case of the SmartFeeder by wedging an iFixit Opening Tool on each side.

Step 5

• Turn the SmartFeeder on its side and with one hand on the base, carefully pull out the central section.
• Place the bottom piece of the device right-side up.

Turn the SmartFeeder on its side and with one hand on the base, carefully pull out the central section.

Place the bottom piece of the device right-side up.

Step 6

• Remove one 10 mm screw by using the Phillips #1 screwdriver.
• Remove the plastic retaining piece for the daughterboard by pulling it out with one hand.

Remove one 10 mm screw by using the Phillips #1 screwdriver.

Remove the plastic retaining piece for the daughterboard by pulling it out with one hand.

Step 7

• Pull the daughterboard out of the device and remove the three-prong connectors by using your hands.
• Hold onto the sockets on the motherboard or you could accidentally pull off the entire assembly.

Pull the daughterboard out of the device and remove the three-prong connectors by using your hands.

Hold onto the sockets on the motherboard or you could accidentally pull off the entire assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Ashley Kim                     

Member since: 10/08/2018

187 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Cal Poly, Team S13-G7, White Fall 2018                        

                                                  Member of Cal Poly, Team S13-G7, White Fall 2018 



                    CPSU-WHITE-F18S13G7                     


                                            4 Members                     


                                            5 Guides authored