Petnet Smartfeeder Sf10E Food Dispensing Wheel Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          6 - 9 minutes

Sections

Food Dispensing Wheel
7 steps

Flags

BackPetnet SmartFeeder SF10E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Food Dispensing Wheel

Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

1024

Step 2

Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.

Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.

Step 3

Remove the black plastic gasket from the top of the SmartFeeder by placing your fingers on the side of it and lifting up.
It should come off very easily.

Remove the black plastic gasket from the top of the SmartFeeder by placing your fingers on the side of it and lifting up.

It should come off very easily.

Step 4

Flip over the SmartFeeder by using both hands.
Partially open the outer case of the SmartFeeder by wedging an iFixit Opening Tool on each side.

Flip over the SmartFeeder by using both hands.

Partially open the outer case of the SmartFeeder by wedging an iFixit Opening Tool on each side.

Step 5

Turn the SmartFeeder on its side and with one hand on the base, carefully pull out the central section.
Place the bottom piece of the device right-side up.

Turn the SmartFeeder on its side and with one hand on the base, carefully pull out the central section.

Place the bottom piece of the device right-side up.

Step 6

Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.

Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.

Step 7

Pull apart the two sides of the central pillar at the top by using both hands.
The two sides will not completely separate at the base.
With the two halves partially separated, pull out the rubber wheel with your hand.
A small black rectangular piece may fall out of the chute when the halves are partially separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute.

Pull apart the two sides of the central pillar at the top by using both hands.

The two sides will not completely separate at the base.

With the two halves partially separated, pull out the rubber wheel with your hand.

A small black rectangular piece may fall out of the chute when the halves are partially separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Louis Squitieri

Member since: 10/08/2018

157 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S13-G7, White Fall 2018                        

                                                  Member of Cal Poly, Team S13-G7, White Fall 2018 



                    CPSU-WHITE-F18S13G7                     


                                            4 Members                     


                                            5 Guides authored

David - Sep 21, 2019

Always nice to have a link to part so we know where to buy

Introduction#

What you need#

Team#

Introduction

What you need

Team