Difficulty

Easy

Steps

9

Time Required

                          20 - 30 minutes

Sections

1

  • Headlamp Bulb
  • 9 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackPeugeot

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bonnet Catch
  • Open the passenger side door to find the bonnet release catch.
  • Pull the catch down and towards you to release the bonnet of the van.

Open the passenger side door to find the bonnet release catch.

Pull the catch down and towards you to release the bonnet of the van.

1024

Step 2

              Secondary Bonnet Catch
  • Once the bonnet is loosened, find the yellow handle of the secondary bonnet catch by feeling underneath
  • Once you locate the catch, push the bonnet catch upwards, this will release the bonnet

Once the bonnet is loosened, find the yellow handle of the secondary bonnet catch by feeling underneath

Once you locate the catch, push the bonnet catch upwards, this will release the bonnet

Step 3

              Open Bonnet
  • Use the strut, located to the right of the hood to prop open the bonnet.
  • Make sure the strut is secure to the hood! If the strut comes down, this may damage your car and strut!

Use the strut, located to the right of the hood to prop open the bonnet.

Make sure the strut is secure to the hood! If the strut comes down, this may damage your car and strut!

Step 4

              Torx Bolts
  • Remove the two Torx bolts holding the headlamp assembly at each corner.

Remove the two Torx bolts holding the headlamp assembly at each corner.

Step 5

              Slide Headlamp Out
  • Gently slide headlamp assembly out
  • Make sure to move the headlight diagonally towards you and towards the centre of the vehicle

Gently slide headlamp assembly out

Make sure to move the headlight diagonally towards you and towards the centre of the vehicle

Step 6

              Rubber Cap
  • Pull the tab on rubber cap, revealing the back of the headlamp bulb.

Pull the tab on rubber cap, revealing the back of the headlamp bulb.

Step 7

              Disconnect Bulb
  • Remove the electrical connection from the old bulb (it should just pull off).
  • Make a note of which way up the plug was for when you connect everything back up again.

Remove the electrical connection from the old bulb (it should just pull off).

Make a note of which way up the plug was for when you connect everything back up again.

Step 8

              Remove Bulb
  • With needle-nosed pliers, carefully ‘wiggle’ the old bulb out from its housing.

With needle-nosed pliers, carefully ‘wiggle’ the old bulb out from its housing.

Step 9

              New Bulb
  • Locate your new bulb. Taking care to make sure it is the right way up, push it firmly into place until you feel it clip in.

Locate your new bulb. Taking care to make sure it is the right way up, push it firmly into place until you feel it clip in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Kit Marsden

Member since: 05/04/2021

196 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges