Philips Emerson Coughassist Ca Series Disassembly Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          5 - 10 minutes            

Sections

1

• Philips Emerson CoughAssist CA Series Disassembly
• 6 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackPhilips Emerson CoughAssist CA Series

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Philips Emerson CoughAssist CA Series Disassembly               

• First, remove the two 16mm pan head screws (1) directly under the front panel of the ventilator. (Page 3).

First, remove the two 16mm pan head screws (1) directly under the front panel of the ventilator. (Page 3).

1024

Step 2

• Next, remove the two 16mm flat head screws (3) from the back panel of the ventilator. (Page 3).

Next, remove the two 16mm flat head screws (3) from the back panel of the ventilator. (Page 3).

Step 3

• Lift off the top cover (2) of the device. (Page 3).

Lift off the top cover (2) of the device. (Page 3).

Step 4

• Now remove the “Inhale flow” control knob (4) and “Inhale pressure” knob (4), by loosening the setscrew on each before pulling off. If you have a CM model, carefully remove the Manual Control Lever (3) by prying it off with the screwdriver. (Page 3).

Now remove the “Inhale flow” control knob (4) and “Inhale pressure” knob (4), by loosening the setscrew on each before pulling off. If you have a CM model, carefully remove the Manual Control Lever (3) by prying it off with the screwdriver. (Page 3).

Step 5

• Unscrew the three 12.7mm plastite screws ( 2) holding the panel assembly to the lower housing. A long Phillips screwdriver is very helpful for access to the three screws. (Page 3)

Unscrew the three 12.7mm plastite screws ( 2) holding the panel assembly to the lower housing. A long Phillips screwdriver is very helpful for access to the three screws. (Page 3)

Step 6

• The front control panel (5) should now be loose. Carefully slide it forwards to remove. (Page 4).

The front control panel (5) should now be loose. Carefully slide it forwards to remove. (Page 4).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Zachary Stednitz                     

Member since: 04/07/2020

292 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Cal Poly, Team S11-G18, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S11-G18, Paton Spring 2020 



                    CPSU-PATON-S20S11G18                     


                                            3 Members                     


                                            3 Guides authored